Carbon steel storage tanks often store some chemical substances, and we sometimes do some processing. The main purpose is to use them better. Seams are mainly an operation performed on the equipment. Pay attention to the following when seaming:

1, Heat welding: suitable for slightly thicker stainless steel tank base material, the weld overlap width is not less than5cm.

2, Overlap: The width of the overlap should be greater than15cm. The thickness is not less than0.3mm, too thin may produce pores and be easily damaged during construction, thus reducing the anti-seepage effect. During construction, special attention should be paid to the correctcarbon steel storage tankThe laying should not be too tight or wrinkled, and the splicing should be stable;

3, The corners of the base should be rounded, and generally the radius of the arc should not be less than500mm.

When doing joint processing on carbon steel storage tanks, users are advised to pay attention to the several precautions listed above and do a good job in welding operations. Avoid equipment leakage. Only in this way can the overall efficiency of the equipment be improved.