A brief discussion on the requirements for welding of stainless steel carbon steel storage tank test plates-Chemical equipment company

A brief discussion on the requirements for welding of stainless steel carbon steel storage tank test plates

1. The welding process qualification test plate should be welded by the unit's welder. The upper limit of the welding parameters is acceptable, and care should be taken to avoid deformation and excessive interlayer temperature.

2,Stainless steel carbon steel storage tankThe welding test plate should be welded by the welder who welds the product, and should be on the extended line of the longitudinal seam with the longitudinal seam of the container.1Finished welding. After welding, the welder's stamp and supervisory inspection code will be stamped. To avoid angular deformation the panels can be stiffened.

32. The welder examination test plate must control the groove gap and blunt edge. During welding, attention should be paid to forming a controllable welding hole in the front of the molten pool to ensure the formation of the back side.

The above are the requirements for welding of stainless steel carbon steel storage tank test plates introduced by the editor. I hope you can understand them.

1344 次

上一篇：Briefly describe the applications and work priorities of carbon steel storage tanks

下一篇：Overview of the safety points of stainless steel carbon steel storage tanks